L · EN 10056-1

L 60×60/7

L 60×60/7 is an equal-leg steel angle per EN 10056-1: leg length 60 mm, thickness 7 mm, weight 6.3 kg/m, cross-section area 8 cm², moment of inertia Iy = 26.1 cm⁴, elastic section modulus Wel,y = 6.1 cm³.

Cross section · mm

60Leg a · mm

7Thickness t · mm

7.98Area A · cm²

6.30Mass G · kg/m

Geometry

Leg length a60.00 mm

Thickness t7.00 mm

Cross-section area A7.980 cm²

Centroid C_x=C_y17.3 mm

Weight G
steel 7850 kg/m³6.30kg/m

Section properties

Moment of inertia I_y=I_z26.050 cm⁴

Section modulus W_el6.101 cm³

Plastic modulus W_pl11.140 cm³

Radius of gyration i_y18.10 mm

Principal axes u–v

I_u41.340 cm⁴

I_v10.760 cm⁴

Reference

Profile standardEN 10056-1

EurocodeEN 1993-1-1 (EC3)

Check to EN 1993-1-1

Work out the utilisation of L 60×60/7 for your design forces

Find the lightest section Compare sections

Enter the design loads and the section is checked for bending, shear and compression with flexural buckling.

Bending/ 1.7 kN·m

Shear/ 63.3 kN

Compression/ 8.3 kN

Steelγ_M0γ_M1L_crmmkClass3

Resistances and factors

M_c,y,Rd / M_c,z,RdW_el1.7 kN·m / 1.7 kN·m

V_c,z,Rd / V_c,y,RdA_v = 399 mm²63.3 kN / 63.3 kN

N_pl,Rd / N_b,Rd219.4 kN / 8.3 kN

N_cr,y / N_cr,v21.6 kN / 8.9 kN

f_yEN 10025-2275 MPa

γ_M0 / γ_M11.00 / 1.00

Curve b · χ0.04

Yield strength is taken from the product standard for the governing thickness, so above 16 mm it is lower than the nominal grade. Simplified checks per EN 1993-1-1, without M+N+V interaction, without lateral-torsional buckling and without web shear buckling. Verify with a full design.

For angles the bending values refer to the axes parallel to the legs, which are not principal axes. A moment about one of them also bends the section about the other, so bending has to be resolved into the principal axes u and v and checked biaxially. Buckling already uses the weaker principal axis v.